当前位置:金沙国际官网-新闻中心 > 新闻中心

金沙国际官网安装注意事项的介绍,你了解多少?

发布人:   发布时间:2019-08-08 19:57:29

  一、金沙国际官网在安装时的注意事项:

  I. Notices for Ventilation Pipeline Installation:

  (1)当风管与风机连接时,应在进出风口处加软接头,其软接头的断面尺寸应与风机进出风口一致。软管接头一般可采用帆布、人造革等材料,软管长度不宜小于200,松紧度应适宜,柔性软管可缓冲风机的振动。

  (1) When the duct is connected with the fan, the soft joint should be addedat the inlet and outlet of the fan. The cross-section size of the soft jointshould be the same as that of the inlet and outlet of the fan. The hose jointcan generally be made of canvas, artificial leather and other materials. Thelength of hose should not be less than 200, the tightness should be appropriate,and the flexible hose can cushion the vibration of the fan.

1.jpg

  (2)当风道与除尘设备、加热设备等连接前,应待设备安装完毕后,按实际测绘的图纸进行预制和安装。

  (2) When the air duct is connected with dust removal equipment and heatingequipment, it should be prefabricated and installed according to the actualsurveying drawings after the installation of the equipment.

  (3)风道安装时,进、出风日宜在风道预制时开出洞口,如需在安装完毕的风道上现开风口,其接口处应严密。

  (3) When the duct is installed, the inlet and outlet days should be openedwhen the duct is prefabricated. If the outlet is to be found in the installedduct, the interface should be tight.

  (4)当输送含凝结水或含湿量较大的气体时,其水平管道宜设有坡度,并在低点处接排水管。安装时风道底部不宜出现纵向接缝,对底部有接缝处应进行密封处理。

  (4) When conveying gas with condensate water or high moisture content, thehorizontal pipeline should have a slope and be connected with a drainage pipe ata low point. Longitudinal seams should not appear at the bottom of the ductduring installation. Sealing treatment should be carried out at the seams at thebottom.

2.jpg

  (5)对输送易燃、易爆气体的钢板风道,在风道连接法兰处应安装跨接线,并与静电接地网连接。

  (5) For steel plate air ducts conveying flammable and explosive gases, across connection shall be installed at the flange of the air duct connection andconnected with the electrostatic grounding grid.

  二、金沙国际官网安装程序:

  2. Installation procedures for ventilation pipes:

  (1)风管组装:当风管较短时,可一次在地面组装而成,当风管较长时,可视安装场地的情况,在地面分段组装。组装时应尽量调整风道的中心度和水平度,避免风管扭曲或上下起波,左右摆龙,每段风道不宜超过10m.组装时,垫片应垫平,法兰螺栓应均匀拧紧,螺母帽均朝向同一方向。

  (1) Air duct assembly: When the air duct is short, it can be assembled onthe ground at one time. When the air duct is long, it can be assembled on theground in segments according to the situation of the installation site. Whenassembling, adjust the centrality and levelness of the duct as far as possibleto avoid the distortion or upside and downs of the duct, swing dragons from leftto right, and each duct should not exceed 10 m. When assembling, gaskets shouldbe padded flat, flange bolts should be tightened evenly, and nuts should be inthe same direction.

  (2)风管就位:风管就位前应检查全部支架的水乎度和标高、检查支架的牢固程度,风管就位可采用直接和吊具两种方法。对风管断面较小,又位置较低的可采用人工就位方法,只需搭设简易脚手架即可。当风管断面较大且管段较长时,可采用滑轮、倒链、大绳等方法吊装。世纪星介绍为了便于风道就位,一般多采用将风道吊在脚手架上,然后再将其抬放在风道支架上的方法。脚手架应沿其风道长度方向搭设,高度和位置应适合施工操作,吊装顺序应先干管后支、立管,吊起时,吊点应牢固,两吊点应均匀受力。垂直风管可采用人工和大绳辅助就位。调整风管保证垂直度要求。

3.jpg

  (2) Air duct positioning: Before air duct positioning, the water alignmentand elevation of all brackets should be checked, and the firmness of bracketsshould be checked. Direct and suspension methods can be used for air ductpositioning. For the smaller section and lower position of the air duct, themanual positioning method can be adopted, and only simple scaffolding can be setup. When the section of air duct is large and the section is long, pulleys,chains and ropes can be used for hoisting. Century Star introduced that in orderto facilitate the placement of the air duct, the method of hanging the air ducton the scaffolding and then lifting it on the air duct bracket is usuallyadopted. The scaffolding should be erected along the length direction of its airduct, and the height and position should be suitable for construction operation.The lifting sequence should first be trunk pipe, then branch pipe and riserpipe. When lifting, the lifting point should be firm and the two lifting pointsshould be uniformly loaded. Vertical ducts can be positioned with manual andlarge rope assistance. Adjust the air duct to ensure the verticalityrequirement.

  (3)风道调直:就位在支架上的风道,应拨正位置,调整风道横平竖直,然后再按图集要求固定。

  (3) Straightening the air duct: The air duct positioned on the supportshould be positioned to adjust the horizontal and vertical air duct, and thenfixed according to the requirements of the atlas.

  以上就是金沙国际官网对于金沙国际官网注意事项的介绍,更多行业信息请联系我们

  The above is the introduction of Shandong ventilation pipeline to thematters needing attention. For more information, please contact us at.


上一篇:金沙国际唯一官网网址的管道特点及应用
下一篇:最后一页

金沙国际官网 关于我们 产品展示 新闻中心 工程案例 在线留言 联系我们

Baidu
sogou